Technical Rider — Behoudenis Der Klanken
Behoudenis Der Klanken
Technical Rider · Production Specification
9 Musicians · 12 Channels
Formation / Active Inputs
3 Aux Sends · Wedges + Wired IEM
Monitor Configuration
4.5 m wide stage
Minimum Stage Requirement
Input Assignment
CH 1–8 · XLR · Phantom-capable · FULLY ASSIGNED
1Trombone (T-Bone Ovid)48V ✓
2Violin — instrument (T-Bone Ovid)48V ✓
3Accordion — instrument (DPA clip)48V ✓
4Vocal — Female 1 (SM58)—
5Vocal — Female 2 (SM58)—
6Vocal — Male (SM58)—
7Violin — vocal (SM58 via Optogate)48V ✓
8Accordion — vocal (SM58)—
CH 9–16 · Line / TRS · No phantom · No preamp
9Bass — SM57 on amp—
10Guitar — SM57 on amp—
11Percussion — Kick (SM57 inside bass cajón)—
12Percussion — Centre (Sennheiser e609 bottom-up on snare cajón)—
13unused—
14unused—
15unused—
16unused—

Phantom power: Channels 1, 2, 3, and 7 require 48V (trombone, violin instrument, violin vocal via Optogate, accordion instrument). Channels 4, 5, 6, and 8 are SM58 dynamics — no phantom.

No spare XLR slot. All 8 XLR inputs are filled. If a phantom-powered channel fails during the show, there is no hot-swap slot available. Band soundperson will need to unpatch a vocal mic if a critical instrument mic goes down. Plan accordingly at soundcheck.

Channels 9–12 are on line-level (TRS) jacks, not XLR preamp inputs. This is a known compromise — the SM57s on guitar/bass amps and the SM57 / Sennheiser e609 on percussion are all relatively hot dynamic sources that should drive a line input adequately when close-miked. Gain must be trimmed carefully in the mixer app; expect less headroom and noise margin than on the XLR preamps. FOH / backline engineers should be aware this is intentional, not a patch error.

Channel Patch Detail
■ XLR (phantom-capable) ■ Line / TRS jack (no phantom) Band = band provides, takes back after show Venue (stand) = venue provides mic stand only
CH Role Source Phantom Hardware Monitor Mix Notes
Brass
1 Trombone T-Bone Ovid clip mic on bell 48V ✓ Band Vox Mix Downstage right. Linked to vocal wedges (AUX 2)
Violin
2 Violin — instrument T-Bone Ovid clip mic on instrument 48V ✓ Band Vox Mix Centre stage. Instrument mic only
Accordion
3 Accordion — instrument DPA clip mic on instrument 48V ✓ Band IEM Downstage left. Instrument mic only
Vocals
4 Vocal — Female 1 SM58 on boom stand None Band (mic) Venue (stand) Vox Mix Main lead vocal, centre stage
5 Vocal — Female 2 SM58 on boom stand None Band (mic) Venue (stand) Vox Mix Downstage centre
6 Vocal — Male SM58 on boom stand None Band (mic) Venue (stand) Vox Mix Downstage centre
7 Violin — vocal SM58 on boom stand via Optogate 48V ✓ Band (mic + Optogate) Venue (stand) Vox Mix Optogate auto-mutes mic when violin is raised to play. 48V powers the Optogate unit
8 Accordion — vocal SM58 on boom stand None Band (mic) Venue (stand) IEM Boom stand at face height. Also sent to Vox Mix at low level
Guitar & Bass — line jacks, no preamp
9 Bass SM57 on amp cabinet None Band Guitar/Bass Mix Upstage right. Line jack input — trim gain carefully at soundcheck. Amp is band’s own
10 Guitar (Electric) SM57 on amp cabinet None Band Guitar/Bass Mix Upstage right. Line jack input. Channel may remain unused if stage volume is sufficient — confirmed at soundcheck
Percussion / Cajón — line jacks, no preamp
11 Cajón — Kick SM57 inside bass cajón None Band Guitar/Bass Mix Upstage left. SM57 placed inside bass cajón port. Line jack — trim gain
12 Cajón — Centre Sennheiser e609, bottom-up on snare cajón None Band Guitar/Bass Mix e609 positioned bottom-up on the snare cajón for slap/snare response. Line jack — trim gain
Monitor Mixes — 3 Aux Sends (AUX 2/3/4 · AUX 1 = Subs)
AUX 2 · Vocal Wedges
2× linked floor wedges — downstage centre + trombone
  • All vocals — prominent
  • Trombone — present
  • Accordion — present
  • Violin — present
  • Guitar / Bass — low
  • Percussion — low

For vocalists (CH 4–6) and violin vocal (CH 7), plus instrument channels 1, 2, 3. Two wedges linked, identical mix.

AUX 3 · Guitar / Bass / Perc Wedges
1× wedge upstage right + 1× wedge upstage left
  • All vocals — present, brighter EQ
  • Guitar — prominent
  • Bass — prominent
  • Percussion — prominent
  • Accordion — low
  • Trombone — low

Two wedges share this single aux send — percussionist (upstage left) and guitar/bass (upstage right).

AUX 4 · Accordionist IEM
Wired IEM — downstage left
  • Female vocals (CH 4/5) — prominent
  • Accordionist vocal (CH 8) — slightly above others
  • Male vocal (CH 6) — present
  • Violin vocal (CH 7) — present
  • Violin instrument (CH 2) — present
  • Trombone (CH 1) — low
  • Guitar / Bass — low
  • Percussion — low
  • Accordion instrument (CH 3) — not in this mix

Power outlet required near accordionist's position (downstage left) for IEM transmitter / belt pack charger.

AUX 1 is reserved for Subs over Aux — low-frequency extension routed separately. Not available for monitoring. The three monitor mixes above use AUX 2, 3, and 4.

Stage Plot — 4.5 m Wide
UPSTAGE AUDIENCE STAGE LEFT STAGE RIGHT 4.5 m FOH mixer AUX2 AUX2 AUX3 AUX3 RISER PERC CH 11/12 GTR CH 10 AMP ⚡ BASS CH 9 AMP ⚡ ACC CH 3/8 VLN CH 2/7 TBN CH 1 VOX F1 CH 4 VOX F2 CH 5 VOX M CH 6 Vocals / Vox mix Gtr/Bass mix IEM (wired) / Accordion Vocal wedge (AUX2) Gtr/Bass/Perc wedge (AUX3)
What the Venue Needs to Provide

PA system
Main stereo PA sufficient for venue size. Subwoofer(s) on AUX 1. Minimum 13 input channels required, with at least 3 aux sends available for monitoring. No specific brand required.

Floor wedges
Minimum 4× floor wedges: 2× downstage centre (vocal mix, AUX 2), 1× upstage right (guitar/bass mix, AUX 3), 1× upstage left (percussion, AUX 3). Powered or passive with amplification.

Vocal mic stands — 5 required
3× boom stands for the three handheld vocalists (CH 1, 2, 9).
1× boom stand for accordion player (CH 7 vocal) — arm positioned at face height while playing.
1× boom stand for violin player (CH 5 vocal) — arm positioned at face height while playing.
All stands should include mic clips.

Power outlets — 3 required
2× mains sockets upstage right for guitar amp and bass amp (band brings both amplifiers).
1× mains socket downstage left for accordion player's wired IEM unit.

Soundcheck time
Minimum 60 minutes. No dedicated engineer needed from the band's side — venue engineer handles the mix. Assistance with initial cable routing to stage is appreciated.

Band brings everything else: All instrument mics (T-Bone Ovid clips, DPA clip, SM57s, Sennheiser e609, SM58s, Optogate) and all XLR/instrument cables. Wired IEM system. Guitar amp, bass amp, cajón percussion kit. All items are taken back after the show.